Hi everyone,
I am trying to model a blended wing body aircraft using surfacing tools. When I try to make the landing gear flow from the wing section, I can not make it such that there is a smooth transition from the bottom of the wing to the landing gear. If you look in my model, the landing gear (Boundary-Surface 5) slightly penetrates the rear end of the wing (Surface-Knit 1) section while it does not for the front end.
The end result I'm looking for is for there to be a smooth flow from the bottom of the wing to the landing gear. Any help would be greatly appreciated!
Cheers,
Andy.
SolidworksSurfacing