I have a part the contains a loft feature from one sketch to another.  I wanted to change the orientation of the first sketch, so I rolled back the feature manager, created a new plane, rolled the feature manager forward and then tried to redefine this sketch to the new plane.  However when I go in to redefine the sketch plane, the new plane is not showing.  Even though the sketch is higher in the feature manager, the sketch still seems to act as if it was created before the plane.  If I delete the loft feature, the sketch jumps up on the feature manager to above the new plane.  At this point I can reorder the feature manager, and redefine the sketch to the new plane.  But, I don't want to have to delete the loft feature.  I have features that are also deleted if I delete the loft.

Is there a way to correct this?

Mitch