Hello,

My Question is: IS THERE A WAY TO LINK TO THE K@Sheet-Metal1

I've seen a lot of advancment in the area of sheet metal in SW over the years.

In the area of detailing a flat pattern drawing I've been able to link to:

to the Radius using:               D1@Sheet-Metal1 (can even control this value with either a table or equation)

to the Thickness using:          "Thickness" (can even control this value with either a table or equation)

BUT to give any setback information I have to manualy enter the value into the custom property tab of the model and link to the custom prop.

I'm aware that there are many options for the Bend Duction / Set Back / K-Factor / Bend Table, but I want to extract the value to my drawing.

Thank you,

Jeff D.