Hello, I got a relatively simple question, but I can't find a solution by now in the program. Actually I want to use jointed fixtures with specific free rotations on a simulation of a plate. By now the only line support I find in SW is completely fixed. In UGS Nastran I could freely set up the fixtures by selecting (lines/areas/points) and then choosing between translation x, y, z and rotation x, y, z wich was quite good.

With beams I had the posibility of using the deposited mass tool but I dont know if thats a good choice for a line support, even its quite complicated to set up because you always need the specific center point.

Thank you

Greetings Wolfgang