Hello -
I was wondering if there's a way to isolate a pair of componentswith a mate error so that it can be seen and repaired easier. I'vegot component descriptions turned on at the end of my componenttree in the mates area and this helps a lot. But, I thought itwould be neat to pick one of these pairs and automatically isolatethem from the rest of the assembly. This would work especially wellif the parts are deep inside!
-LouSolidworksAssemblies
I was wondering if there's a way to isolate a pair of componentswith a mate error so that it can be seen and repaired easier. I'vegot component descriptions turned on at the end of my componenttree in the mates area and this helps a lot. But, I thought itwould be neat to pick one of these pairs and automatically isolatethem from the rest of the assembly. This would work especially wellif the parts are deep inside!
-LouSolidworksAssemblies
