I want to make a slot 1" in by 2" by 3" deep.
I want the slot to be 1" by 1.5" at the bottom, so the short side will not taper but the long side will.
I tried using DRAFT, but that tapered the entire shape.
SolidworksSketching
I want to make a slot 1" in by 2" by 3" deep.
I want the slot to be 1" by 1.5" at the bottom, so the short side will not taper but the long side will.
I tried using DRAFT, but that tapered the entire shape.
SolidworksSketching