How to run multiple NL-static studies (multiple varying geometrical parameters) similar to a design study.

Hello everyone,

I'm trying to converge to an appropriate design for a lip-seal. I'd like to run multiple parallel studies with varying fillet radii, and angles. But I can't seem to figure out how this works.

As of right now I'm running Non-linear-static studies with axi-symetric simplification and the simulation is basicaly moving the shaft through the lip-seal and recovering the traction&compression stress values.

So would there be a way to fill a list of values for each important geometrical parameter and run every simulation at once ? 

Thanks in advance for the help,

Have a nice day.

Kevin.

SolidworksSimulation