Dear all,

I was running transient radiative thermal analysis. It took about 40 hours to finish the simulation. Unfortunately, I didn't save the results in time, and the SolidWorks Simulation re-start the analysis automatically! I had to wait for another 40 hours to get the results.

This incidence has happened for two times and might be many times during weekend run. In one case, I set up a transient simulation before my 4-day vacation, when I came back 4 days later to check the simulation results, the Study status showed around there was only 3 hours Elapsed Time, which means it just started again 3 hours before I came back to my office.

Is there any hints to resolve this issue?

Thanks for any feedback.

Best regards,

Tiefu