First, I want to appologise, I started a thread yesterday, and some people have asked for a part attached, after I attached it, basicly noone entered the thread. I am desperate and I hope it is fine, to post here a new thread this time with a simple example of what is goin to kill me soon ...
AAAAARGH
So, I kindly ask you for help with following file.
Here are few steps that drives me crazy:
1 I open part and go to sketch1
2 I delete the crippled dimension
3 I place the dimension between the O/D (black line) and the longer axis (used for revolution)
4 I close sketch (go to part enviroment)
5 I open sketch again - the dimension cripples again and it is on completely different place then it was when you left the sketch ....
So there is no way, how to make a correct dimension of the O/D
Sorry for duplicate post (I am an expert on this ) and thanks for any help in advance !
SolidworksSketching