Long story short, I didn't load SW2008 on my computer untillate last fall. My employer decides everything is working fine withit so they don't renew our SW contract this year in order to save\$. So this month my computer implodes and our IT guy brings in anew one. I only have service pack 4 for 2008 and without renewingcan't get service pack 5. Our local SW supplier was good to workwith and said SW4 should work with all the routing I am doing.
Finally got the computer up and running and everything loaded andstart working on finishing some projects. We are a Hto tubmanufacturer and I use the routing software to make our 3dproduction sheets and Boms. I am reworking some files I worked onearlier this year and have deleted several routes. Now when I makethe new ones everything looks fine until I save the route aftercreating it. Then the route solid dissapears leaving only the firstroute stub that was created while doing the Autoroute. If I go inand "edit route" the solid reappears until I save it again.
I have even gone in and created new fittings as an experiment andtried routing between two of them with the same results. I'm sureI'm just missing some setting, but I've tried changing the Realview, display and transparency functions but can't get anything butthe start of the route to show. These are curved routes and theroute path is there, just not tubing. Any help would be greatlyappreciated.
SolidworksRouting
Finally got the computer up and running and everything loaded andstart working on finishing some projects. We are a Hto tubmanufacturer and I use the routing software to make our 3dproduction sheets and Boms. I am reworking some files I worked onearlier this year and have deleted several routes. Now when I makethe new ones everything looks fine until I save the route aftercreating it. Then the route solid dissapears leaving only the firstroute stub that was created while doing the Autoroute. If I go inand "edit route" the solid reappears until I save it again.
I have even gone in and created new fittings as an experiment andtried routing between two of them with the same results. I'm sureI'm just missing some setting, but I've tried changing the Realview, display and transparency functions but can't get anything butthe start of the route to show. These are curved routes and theroute path is there, just not tubing. Any help would be greatlyappreciated.
SolidworksRouting