I am new to sheet metal and have used the edge flange a lot with no problems. But now I am doing a bend with tight corners and can’t get the two bends to clear themselves? I don’t understand the miter flange and it is probably what would work best.  I can get the flange to work on one edge but can’t get it to work on the other three edges. I also don’t understand the “propagate” and can’t find it. Any help would be greatly appreciated

SW 2010 sp 2.0

Thanks,

Bob Switala

Port City Metals

Tulsa Ok 918-583-2222 ext.328

Bswitala@metalsusa.com