Hi,
I've imported a parasolid project from one our external designer.
He uses NX.
I would like to ask to you if I can plot the result on mycoordinate system and not from original SolidWorks assemblycoordinate system.
For example in NX the Z is Y SW axis.
When I import, you can understand the situation.
Assembly is big, so I don't want to rotate or move the entireassembly.
If I create a new coordinate system, can I set Simulation to showmy FEM result to my new coordinate system ?
Another question is how can I simplify parts to avoid lot ofmeshing time ?
A lot of parts are cast parts, so they have lots of fillets.
I can't use FeatureWorks (I tested but doesn't recognize fillets)because there are lots of cast parts.
Simplify mesh is not good.
Thank you for the possible suggestions,
SolidworksSimulation
I've imported a parasolid project from one our external designer.
He uses NX.
I would like to ask to you if I can plot the result on mycoordinate system and not from original SolidWorks assemblycoordinate system.
For example in NX the Z is Y SW axis.
When I import, you can understand the situation.
Assembly is big, so I don't want to rotate or move the entireassembly.
If I create a new coordinate system, can I set Simulation to showmy FEM result to my new coordinate system ?
Another question is how can I simplify parts to avoid lot ofmeshing time ?
A lot of parts are cast parts, so they have lots of fillets.
I can't use FeatureWorks (I tested but doesn't recognize fillets)because there are lots of cast parts.
Simplify mesh is not good.
Thank you for the possible suggestions,
SolidworksSimulation
