Failing Temperature condition

Looking for some thoughts .. I am running a transient thermal simulation & my first condition where I set all my components to an initial temp is failing .

The model is meshing in a quarter-symmetry config & will process w/o the one condition.. but the results are not viable since the start temp is failing.

I had tried it with setting faces, switched to selecting the components from the model tree but no success. I tried deleting & recreating but it repeated. Very consistently.

Did the same thing w/o the quarter model. Some components did not mesh, but it modeled the thermal model w/o the init temp.

Suggestions?

Thx, Tom D.

SolidworksSimulation