I have a Dell 6400 that is docked and 2 monitors connected to the docking station. The Dynamic highlight does not work whenboth monitors are plugged in. When use just the laptop it works fine. Has anyone else seen this, and if so did you get a solution to the problem?
I guess my beef is if the hardware supports Dual Monitors, then why doesn't SW support this setup? After all Solidworks does support Dual Moniters setup.
I already been through the VAr route and that didn't work, hoping someone out here has found away around this, other than dropping one monitor or using the laptop monitor. I cannot see the laptop monitor, which is why I opted for 2 regular ones.
Note one monitor is on a VGA cable and the other is on DVI. 2 DVI (which is on the docking station) cables would not work with this type of setup at least our IT could not figure itout.
Regards,
Scott Baugh, CSWP
CAD Administrator
SolidworksGeneral