I finally discovered a proper work flow but I can't get the bend annotations to stop showing up in my dxf drawings. I strictly build metal parts and almost always they are mad of sheet metal and structural members. After creating an assembly I create a drawing 4' X 8' to lay the flat patterns in to. Then those need to be saved to dxf or dwg to become g code. But even after I turn off all the annotation in the drawings environment the up 90 degrees and and down whatever annotations are still in the dxf. This means the plasma is going to try and cut the up 90 out of the plate. I am pulling my hair out over this because I have to send these out of state at the moment to our shop and they only use auto cad there. really in trouble if i cant fix this any help would be greatly appreciated. Thanks in advance