Dual Dimension Tolerance Rounding

Is there any option to facilitate method "b" rounding of dual tolerances? We use "inward" tolerances which rounds the high end down and the low end up. Example:

Primary units in mm 1.5±0.5, alternate units inches. Dual dims in SW displays 2.00/1.50 [.079/.039]. This gives me a dual unit tolerance of .040" which in reality is too large. Calculated dual tolerance would be .078/.040 (from .07874/.03937) when rounded "inward" which is a tolerance of .038". Is there any way to set the dual dimension tolerancing to "inward" rounding?

Thanks,

HB

SolidworksDrawings And Detailing