I have a part made from a series of lofts (4 totals). Both ends of the part have been filleted and the loft themselves are farely complexe. I am having a very hard time putting the part on a 2D drawing and dimensioning it. Ideally I would want a secion for each loft sketch, but I am having the following problems:

- I can't snap sections exacply at the loft sketch (I can get close, but not snap exactly on it).

- I can't dimension most features because most of the entities "cannot be converted to lines or circular arcs."

What is the best procedure for this kind of problems? Thank you.