Can we be able to configure more things in a design table.
In assemblies we should be able to configure all things in component properties. These things are configurable, but no sytax in design table?
This is my order of preference, but I'm sure this is debatable.
Display state!!!!!!!!
Flexible/rigid
Lightweight (Instead of just suppress/unsuppress)
Speedpack (Used, or unused in given config)
Hide/Show
Exclude from Bill of materials
Float/Fix
Component Display
I would say global variables because for a long time it was not really working. I did a brief test and it actually seemed to be working in 2012 SP3 as I would expect without overwriting design table values on config switch. I haven't tested fully yet though.
Solidworks