The following custom properties were not updated:

\\\$prp@length

\\\$prp@weight

This is the error I recieve when I exit the design table now that I am on 2013. In 2012 it worked fine. I link my Weight to the Mass pull down in file properties. Then add a \\\$prp@weight column in the design table so it updates. Used to work fine. Now the weight shows the same for every configuration preceeded by an astrics. ex:  *22

Same thing is happening for length. Seems that anything that is variable in the properties is subject to this behavior. Thinks like part numbers are stable as they don't change.

Has anyone seen this? I have discussed with my VAR and it was sent to SW for review. Please chime in if you have similar experience.

Thanks,

Steve