I need a little direction here.

I have Ejector Pin file set up in the design library. I want tobring a pin into the assembly and mate it into position. (up tohere I am fine.)

Now, I want to save this as a new part in the mold assemblydirectory, give it a new name (for detail number), and then cut itto length without affecting the library part.

I have been doing this using the 'file, save as, references' andthen assigning it to the new directory. I then close it, and useexplorer to rename it.

Is there an easier way to bring it in, and then break it links tothe library?

thanks for your help

MichaelSolidworksPlastics And Mold Design