See if I can make some sense o this...

Upgraded to 2012 version using a clean install just a few weeks ago.. sp1 by the way.

Moved and linked all the custom files and other paths and all works, but.

Used a custom properties setup to add ..drawing name, drawing number etc. all though 2011 to project models. With and without configurations in them.

Now opening up the 2011 files the custom properties don't reload into there spots in the flyouts listings. All seem to have been moved to the Custom Tab in the Summary Information dialog. Where in 2011 the values I added stayed in the Configuration Specific tab even if I did not have any config's in the part.

Now the parts that did have config's in them do pass some of the properties over into the custom properties flyout but not all. These seem to split between the custom and config' tabs in the summary information dialog.

Anyone know of a fix or have seen this. Maybe something in the way I setup the program.

Thanks,

jb...