We have noticed that the amount of configurations in a partor assembly impact performance.
I know that I have been informed over the years to keep likemanufactured parts to a single file and go with configurations.
Example: rectangle that is 19.05mm thick and "Y" direction it is70mm, has total of 4 holes on its ends (2 holes per each end), thepart is only grows in width as in the "X" direction
Is there any rules and or thoughts on configurations?
SolidworksParts And Features
I know that I have been informed over the years to keep likemanufactured parts to a single file and go with configurations.
Example: rectangle that is 19.05mm thick and "Y" direction it is70mm, has total of 4 holes on its ends (2 holes per each end), thepart is only grows in width as in the "X" direction
Is there any rules and or thoughts on configurations?
SolidworksParts And Features
