Hey all,

We have a pipe support that we have set up as a configurable assembly who's configurations determines the number of pipe supports, i.e. configuration 3 can support 3 pipes. We have created a drawing sheet that has all of the configurations on it and dimensions and what not. We add this sheet to all our drawings and then use split balloons to reference the sheet number and also which detail on that sheet we are referencing.

The issue right now is I have a custom property which is configuration specific, i.e. for 2 pipe supports the property reads "B". When calling out these supports on the drawings I want the top of the balloon to pull in the custom configuration property, but currently it is pulling in the part properties and not the assembly properties.

Any ideas?

Thanks!