When adding a centerline to holes in a section there arevarious methods to achieve the same result.
I would like to inquire abot two ways.
You can pick both sides of the hole and a centerline will beplaced in between.
Or you can pick the unsectioned part of the hole, (Side of thehole if you will), and a center line will be placed in the sameposition as the above method. Saving a step.
My problem is, sometimes when you use method 2 all of thecenterlines appear for the pattern and the only way to get rid ofthem is to undo.
This is not a big problem, but sometimes when this happens theundo button goes gray, then it becomes a pain int you know where todelete all of the lines.
I have used the insert model item center line but this seems towant to inserrt more centerlines than are neccessary also.
Anybody else experiencing problems like this or is it me?
SW 2008 SP 4.0
Dell Precision 690
Nvidia Quadro fx 3500
B. B.SolidworksDrawings And Detailing
I would like to inquire abot two ways.
You can pick both sides of the hole and a centerline will beplaced in between.
Or you can pick the unsectioned part of the hole, (Side of thehole if you will), and a center line will be placed in the sameposition as the above method. Saving a step.
My problem is, sometimes when you use method 2 all of thecenterlines appear for the pattern and the only way to get rid ofthem is to undo.
This is not a big problem, but sometimes when this happens theundo button goes gray, then it becomes a pain int you know where todelete all of the lines.
I have used the insert model item center line but this seems towant to inserrt more centerlines than are neccessary also.
Anybody else experiencing problems like this or is it me?
SW 2008 SP 4.0
Dell Precision 690
Nvidia Quadro fx 3500
B. B.SolidworksDrawings And Detailing