Hi All
I have a sketch with 4 parallel lines. There are no relationshipsbetween the end points of each line. The only relationship is thelower line end point coincident with an edge. I am unable to dragany of the end points of any of the lines, even though the linesare under defined.
Has anyone seen this before. See video attached
Using SW 2009 SP2
Cheers
SteveSolidworksSketching

I have a sketch with 4 parallel lines. There are no relationshipsbetween the end points of each line. The only relationship is thelower line end point coincident with an edge. I am unable to dragany of the end points of any of the lines, even though the linesare under defined.
Has anyone seen this before. See video attached
Using SW 2009 SP2
Cheers
SteveSolidworksSketching