Good morning all,

Today I discovered I have a big problem with a few round parts that I have detailed using section views. I initially created what I thought was an aligned section view by sketching two lines and then using the section command. The angle of the bent portion of the section lines were so shallow that I didn't notice that the bottom half of my section views were foreshortened and spent a considerable amount of time dimensioning before I realized what was happening.

By browsing the forums I now know I should have used the Aligned Section command instead. Is there any way to convert from a standard section to an aligned section, or am I stuck with the task of deleting the section views and starting over again?

Thanks!