Hi all,

I know that this question is slightly similar to a few others, but I don't think it's the same.

I am wondering if it is possible to use a macro to re-name a drawing sheet, pulling the name (a partnumber) from a static table on that sheet?

The partnumber is in the exact same position on every sheet, and this would only have to be done once. It doesn't need to update. If the table is changed then the macro could be run again.

We work with a lot of weldments, and each body of a weldment has it's own drawing sheet. The static tables have already been filled out so that the partnumber within is the partnumber of the body shown on the sheet. If I was able to re-name the sheet that partnumber, then it becomes much simpler to create an individual DXF for that body.

Like I said, I'm not really sure if this is possible. But if it is then any help would be greatly appreciated!