Hi everyone,

I need some advice in managing the References of the cables routed from on part to another in Solidworks Professional edition.

I used the "Electrical" Add-In. There are 72 cables terminated with cable lugs, which I routed from a transformer into a Enclosure panel. There is no problem with the start and end points but with the route path. The cables run for 12 to 16 meters from each phase of the transformer into the Enclosure and I used the multiple rows of Trefoil Koz Cable Clamps. 

These KOZ clamps are a part of different sus assembly, which is the inserted to the top level assembly which has the cables. The issue is I'm losing the axis reference of the KOZ cables clamps and the Cables trace the Clamps axis all the way to the other end of the connection. Now when I change the position of the clamps the cables are not rerouted to the new path.

I know one of the way is to pull the clamp inside the Cabling assembly, but One pair of the KOZ clamp is used to route 9 cables and I will end up repeating the same clamp again and again.

Do you have any suggestions to maintain the routing references? Or may be a different approach for this type of cable routing?