Hey, I am creating some assembly drawings and I am running into an issue. I can't get a custom property to fill in a balloon for components within a sub assembly. I have it working in a different assembly drawing but this new one will not comply. Not sure what the difference is. Both have the same set up with assemblies/subassemblies/components. They both contain the same Custom Property information.

It goes

Assembly: E1 - WE A

Sub assembly: E1 - WE A - BSH A+20mm

Component: US_CH20_3507

I'd like to attach a balloon to the component and use the custom property "Position" to get the number "3507" to show up inside the balloon

A different Drawing is laid out as follows

Assembly: E2 - Sidewall A

Sub assembly: E2 - Sidewall A - BSH A+20mm

Component: US_CH20_0372

This one I can put balloons on every component and get the custom property I need.

I already read that SW does not handle attaching balloons to sub assemblies well and pulling component information but I am puzzled as to why it works in one scenario but not in a different one (That I believe to be identical.)