First, I know ther is another thread with a relatedtitle/topic but my issue is different.
I am creating line schematics for a hydraulic installation. Icreate my BOM by first throwing all parts in an assembly to drivethe BOM I show on pg1 of the drawing. I then pull in separateindividual drawing views so I can orient them as necessary for theschematic. Some items show up as * while most seem to work justfine. I have made sure that all individual drawing views are linkedto the BOM.
For the final product I was going to hide the view on pg1 makingits only purpose to drive the BOM. As you can see the parts inquestion balloon fine in that view. It's on pg2 that the items donot balloon correctly even though most other parts do.
Note: The small manifold on the far left of pg2 doesn't have anyconfigurations other than default.SolidworksGeneral
I am creating line schematics for a hydraulic installation. Icreate my BOM by first throwing all parts in an assembly to drivethe BOM I show on pg1 of the drawing. I then pull in separateindividual drawing views so I can orient them as necessary for theschematic. Some items show up as * while most seem to work justfine. I have made sure that all individual drawing views are linkedto the BOM.
For the final product I was going to hide the view on pg1 makingits only purpose to drive the BOM. As you can see the parts inquestion balloon fine in that view. It's on pg2 that the items donot balloon correctly even though most other parts do.
Note: The small manifold on the far left of pg2 doesn't have anyconfigurations other than default.SolidworksGeneral
