Hello,

I have created a simplified assembly to demonstrate a problem I amhaving when trying to balloon different configurations of a part.

Please see the (2) jpegs I have attached.

Item 2 is a piece of channel - this is the 'default' config.

Item 3 is the same part, but is the 'mirror' config.

I have inserted a view of the channel-'default' config. When I adda balloon it calls out Item 3, the 'mirror' config!

One of the jpegs I've attached confirms that the default config isselected (under properties).

The view is linked to the BOM under properties as well.

Any advice as to what might be going on?

Thank You!
SolidworksDrawings And Detailing