Is it possible to assign units to the result of an equation.  I'm able to assign units to constants, and for the most part SolidWorks does a good job of carrying those through to the result, but in a few cases it fails.  Either the wrong units, or no units are assigned to the result.

For example:

"DiametralPitch" = 32    ;units are teeth/in but no way to assign that

"NumTeeth" = 16   ;numteeth is unitless

"PitchAngle" = 360deg / "NumTeeth" = 22.5     ;result should be degrees, but no units assigned

"PitchCircle" = "NumTeeth" / "Diametral Pitch" = 0.5    ;result should be inches but no way to assign that

In the above cases, I can force the correct units to be assigned by multiplying by 1deg or 1in (i.e. = 360deg / "NumTeeth" * 1deg), but that just muddies the equation and will leave someone asking "where did the *1 come from?"

Hence my question.  Is there some way to assign units to the equation result that I'm missing?  If not, how about an enhancement?

Cheers,

Tom