Hello,
We are working with large assembly files and have sub-contractedout some of the sub-assemblies. When we receive them via a zipped'pack-and-go, and unzip, we get all of the sub-contractorsdirectory structures - which match ours only at a certain point.Subsequently, the assemblies cannot locate the files in ourdirectories.
I remember, working with Pro-E, that you could just set up yoursearch paths in your config file and it didn't matter where a filewas located (as long as it was in your paths). Has anyone found away, or could recommend a way for us to gracefully handleexchanging files - without shelling out 10k for the PDM package?
Thank you so much!
SolidworksAssemblies
We are working with large assembly files and have sub-contractedout some of the sub-assemblies. When we receive them via a zipped'pack-and-go, and unzip, we get all of the sub-contractorsdirectory structures - which match ours only at a certain point.Subsequently, the assemblies cannot locate the files in ourdirectories.
I remember, working with Pro-E, that you could just set up yoursearch paths in your config file and it didn't matter where a filewas located (as long as it was in your paths). Has anyone found away, or could recommend a way for us to gracefully handleexchanging files - without shelling out 10k for the PDM package?
Thank you so much!
SolidworksAssemblies
