All dimensions are not shown

Question if I may please.  After creating a fully constrained and not OVER constrained sketch and I exit the 'edit sketch" mode, why do only two dimensions(angular dims) remain visible and not the others?  I basically have a box that is dimensioned at the top width wise and to the plane that divides the box in half vertically.  The base of the box is constrained to a horizontal plane vertically.  I have dimensioned the height.  I have also put the vertical walls at a 2 degree angle to eachother and 1 degree to the vertical plane that again divides the box vertically.  I know SW does draft but I am just trying this to learn.  Why upon exiting the sketch do only the 2 angular dims show and not the other linear dims?

Thank you all.

Sid

SolidworksSketching