Hi
I have a Sheet Metal part that is a piece of metal with a slightcurve. I created it simply by extruding from a curved line derivedfrom reference geometry in an assembly sketch.
I can unfold and fold up the part no problem.
What I need to do is unfold the part, add some holes to it in theflat, and fold it back up so the holes twist with the curve of thepart. Obviously the problem is that if I unsupress the Flat-Patternat the end of the feature tree, anything I add from that point onwill disappear once the Flat-Pattern feature is re-supressed.
What is the correct way to do this?
ThanksSolidworksSheet Metal
I have a Sheet Metal part that is a piece of metal with a slightcurve. I created it simply by extruding from a curved line derivedfrom reference geometry in an assembly sketch.
I can unfold and fold up the part no problem.
What I need to do is unfold the part, add some holes to it in theflat, and fold it back up so the holes twist with the curve of thepart. Obviously the problem is that if I unsupress the Flat-Patternat the end of the feature tree, anything I add from that point onwill disappear once the Flat-Pattern feature is re-supressed.
What is the correct way to do this?
ThanksSolidworksSheet Metal