I am needing to see if anyone can tell me how to representthe following in my part file.
We will take a flat sheet that is like 2" wide and about 4.8" long.We put a 1/2" hem on the part, the send it through the brake andput a 3" I.R. on the part.
In my assembly, I only show the rolled piece with out the hem onit. Earlier this week, the sales guy was showing the edrawing to apotential customer and they noticed the lack of hem on this part.Now the sales guy has the upper management on me about getting thehem shown on there.
How would I go about doing this?
Thanks so much for your help.SolidworksSheet Metal
We will take a flat sheet that is like 2" wide and about 4.8" long.We put a 1/2" hem on the part, the send it through the brake andput a 3" I.R. on the part.
In my assembly, I only show the rolled piece with out the hem onit. Earlier this week, the sales guy was showing the edrawing to apotential customer and they noticed the lack of hem on this part.Now the sales guy has the upper management on me about getting thehem shown on there.
How would I go about doing this?
Thanks so much for your help.SolidworksSheet Metal