Hi all, I am listing a few things below that I have come across in the current version of SW 2013 SP3 Simulation, please comment if you have found a work-around or solution to any of them?

- The symbols for loads and fixtures are very temperamental, they show now and then, sometimes one of two loads shows, sometimes fixtures don't show and I have no idea why? They are not hidden and the symbols are turned on, as some of the symbols still come up.

- The current config sometimes jumps, unprompted, between the default and exploded configurations.

- When editing the values of a thermal resistance contact or the gap clearance of a no pen contact, a remesh is forced and apparently this wasn't always the case?

- Switching between different configurations sometimes causes the mesh to be out of date, even when returning to the correct configuration.

- I have no idea what the "An element type is not available for Elastic Support #"?

Lastly, is there a way to set the default type for the result plot "Save as" option to .JPEG?

Thanks!