I have a small query when i created the prismatic mechanism in the equipment design app i was able to jog the plate but in equipment simulation app where the control equipment was equipped for the conveyor so the motion controller was set up when i tried to jog using the jog mechanism i couldn't see the plate moving over the conveyor though the home positions were defined as you can see in the video. Nevertheless, when I had defined the mechanized conveyor as a tool equipment rather than the conveyor i was able to jog it as seen in the picture below. May i know why is it happening and how to make it work even after defining it as conveyor and in case if it its not possible to jog it by defining it as a conveyor then if its defined as a tool equipment will there be any issue while defining the factory flow.

  DELMIA  Plant Layout Design  ​​​​​​​Edu ​​​​​​​