I am having an issue where I am unable to complete flow calculations. Upon running even a simple flow simulation I come across the application getting stuck on "preparing model" message. The meshing I have set is at the absolute minimum, and doing a simple cube without any complexities to ensure shape was not causing the issue. I reinstalled Solidworks as well, but no fix in sight. I have tried to let it run, but it has been 3 hours and has yet to change status. I managed to run on a much lower-end system, and was able to complete the simulation in less than a minute without any issue. Would like to know if anyone else has experienced this issue, and if so, any way to clear this up? Thank you.