I'm still new with Solidworks.
In the attached picture, how do I make the trim option cut the blue angle square verses shaping around the intersecting angles? The butt trim will only allow one member for the Trimming Boundary selection.
This is a very common intersection, at least for me, so I'm sure there is a way.
Thanks,
BillSolidworksWeldments
In the attached picture, how do I make the trim option cut the blue angle square verses shaping around the intersecting angles? The butt trim will only allow one member for the Trimming Boundary selection.
This is a very common intersection, at least for me, so I'm sure there is a way.
Thanks,
BillSolidworksWeldments
