Hi
Is it possible to take the properties of a weldment section (e.g.no-off, cut list number, mass) and link them into a note, e.g.:-
ITEM XX (Where XX = cut list item number)
Y-OFF REQ'D (where Y = number of equal sections)
Regards
DavidSolidworksWeldments
Is it possible to take the properties of a weldment section (e.g.no-off, cut list number, mass) and link them into a note, e.g.:-
ITEM XX (Where XX = cut list item number)
Y-OFF REQ'D (where Y = number of equal sections)
Regards
DavidSolidworksWeldments
