Isn't anyone else irritated with the problem of insertingflat patterns using the view palette?
I submitted this to my VAR the very first day I started using 2007and a SPR was submitted but it hasn't been adressed in the sp'sfrom what I can see.
If you use the view palette to insert a flat pattern into yourdrawing it does not use the same naming convention if you were toinsert it the normal way. This creates major problems in parts withmultiple configurations.
I can't believe no one else has complained on here about it. I haveturned off the view palette and am not using it until they getthings fixed. Please send an enhancement request if this isbothering you too!!SolidworksSheet Metal
I submitted this to my VAR the very first day I started using 2007and a SPR was submitted but it hasn't been adressed in the sp'sfrom what I can see.
If you use the view palette to insert a flat pattern into yourdrawing it does not use the same naming convention if you were toinsert it the normal way. This creates major problems in parts withmultiple configurations.
I can't believe no one else has complained on here about it. I haveturned off the view palette and am not using it until they getthings fixed. Please send an enhancement request if this isbothering you too!!SolidworksSheet Metal
