Using Routing to model hydraulic hoses

I just started using Routing to model the hydraulic hoses onour products. I added CPoints to my hydraulic fittings and routinghoses between fittings works fine.

My question is the ends of the hoses, SW doesn't appear to havehose ends (typically female JIC swivel in our case) in the Routinglibrary. Straight ends can be added to the hose later but I'm thinkabout 45 and 90 degree ends. Would I have been better off modelingthe hose ends, adding the CPoint to them and using the hose ends asthe start of the route?

Anyone else using Routing to model hydraulic hoses? How do you doit?SolidworksRouting