using smart fastener, i get the following error 'unable toopen part file " Z:\prt\...\bms_4-40
ph.sldprt' then after closing that i get 'unable to setup validspeciications for part number ID'AI_Bolts_and_Screws_BMS_4-40PH_00010443_PN' from source table"AI_type_BS"
we are using last rev of SW6, we recently changed file structure ona new network, so the 'z:\prt\..' no longer exsists, but i cantfind anywhere to redirect it. i tried the toolbox 'brouser config'and the 'add my parts' but to no avail. can anyone help?
thanks,
kevinSolidworksToolbox






ph.sldprt' then after closing that i get 'unable to setup validspeciications for part number ID'AI_Bolts_and_Screws_BMS_4-40PH_00010443_PN' from source table"AI_type_BS"
we are using last rev of SW6, we recently changed file structure ona new network, so the 'z:\prt\..' no longer exsists, but i cantfind anywhere to redirect it. i tried the toolbox 'brouser config'and the 'add my parts' but to no avail. can anyone help?
thanks,
kevinSolidworksToolbox