The part is modeled to the blanking dimensions for thisoilfield thread.
I have the profile of the thread and it's located on the rightpitch.
Can someone show me how to properly close the profile and revolvecut it so that the vanish point ends 1.625 back. The taper is 3/4"or 1.7899 degrees. ThanksSolidworksParts And Features
I have the profile of the thread and it's located on the rightpitch.
Can someone show me how to properly close the profile and revolvecut it so that the vanish point ends 1.625 back. The taper is 3/4"or 1.7899 degrees. ThanksSolidworksParts And Features
