I read a post a while back, but can't find it now, abouttrouble with parts having sweep and loft features not displayingproperly in section/detail views. We went through this yesterday,lost a BUNCH of time, but when the drafter selected the check boxto "display surface features" in the view dialog, presto!! the partdisplayed fine. We re-did the view a couple times and with the boxunchecked, the part WOULD NOT display, and with the box checked, itdisplayed every time. The part is very large, 4+Mb, and is acasting, so it's mostly lofts and sweeps. A little success goes along way, especially when the project is all but done!!SolidworksDrawings And Detailing