SW AND EDGECAM

We are currently using SOLIDWORKS to design our componentsand EDGECAM to generate our tool paths. When we have the twoprograms open together the PC becomes very unresponsive and tendsto run at a snails pace. We understand that EDGECAM will onlysupport 2G of RAM and is not multi threaded so EDGECAM seems to bethe problem. Has anyone else run into this problem and are thereany ways round it because it is desirable to have the two packagesopen together. We have invested a lot of money and training inEDGECAM so it will not be a case of throwing EDGECAM in the trash.

Thanks
SolidworksAdministration