We have an area, were we need to create smooth transitionsurfaces and all edges require tangency. As this will be a chromepart any deviation above .05 degree whould most likely show up inthe part.
I have attached an image that shows the "roughed in surfaces" inorder to help communicate the end form we are trying to achive. Atthis point the edges are not tangent........
Any thoughts or suggestions would be helpful, I can also post a swfile.
Chevis W.SolidworksSurfacing
I have attached an image that shows the "roughed in surfaces" inorder to help communicate the end form we are trying to achive. Atthis point the edges are not tangent........
Any thoughts or suggestions would be helpful, I can also post a swfile.
Chevis W.SolidworksSurfacing