Hi all.
I want to make a smart component of an 80/20 AnchorFitting(Banjo). It is just a blind hole near the end of anextrusion. I'vegot a handle on how to do this, but the sticky partis, I wouldlike to drag the 'smart' banjo into the assembly (so theB.O.M. iscorrect) and have the corresponding hole be pushed back totheframe at the part level.
You need to understand that the frame itself is a multi-bodypart,a weldment. I find that to be a very efficient way tomakeframework. The cut list is a most excellent feature.
Any thoughts??
SolidworksAssembliesI want to make a smart component of an 80/20 AnchorFitting(Banjo). It is just a blind hole near the end of anextrusion. I'vegot a handle on how to do this, but the sticky partis, I wouldlike to drag the 'smart' banjo into the assembly (so theB.O.M. iscorrect) and have the corresponding hole be pushed back totheframe at the part level.
You need to understand that the frame itself is a multi-bodypart,a weldment. I find that to be a very efficient way tomakeframework. The cut list is a most excellent feature.
Any thoughts??