Hi,
I need to create a sheet metal cabinet, preferably from one sheet. It is as drawn in the attached part file except i need the front face to be angled so that from above one side of the cabinet is 500mm and the other 400mm.
Until this point the part is only a couple of minutes work using the mitre flange function, however i can't see a solution to this where i can easily adjust the facing angle without creating each flange individually and tweaking the geometry to make it work.
Thanks.
As part of the migration from the legacy Forum to the new SOLIDWORKS Forum, there was an overlap in timing where the new Forum was being loaded with historical data from an export migration, while at the same time, the legacy Forum was still operating during the period of March 12th to March 31st. Due to the overlapping timelines and import-export technical issues, posts during that time-frame could not have their media imported. If you created a post in the legacy Forum during that time-frame and wish to update the post in the new Forum with supporting media, please go to your post in the new Forum, enter into Edit mode and re-add any supporting media you want to insert.
The easiest way to find your posted content is: from the new Forum, click on your profile icon in the top right of the GUI, then select "My Profile" and you will be taken to the "Overview" tab where you can see all of your posting history.
Thank you